FPGA chip hardware periphery design
$750-1500 USD
K zaplacení v momentě doručení
Design a small PCB (~20x25mm) around an bear-bone FPGA-chip (XC7A15T-1CPG236C) that is able to configure itself on every power-up from a flash memory that can be also found on the PCB. Also it is necessary to design a programming interface for the flash memory on the PCB as it should be possible to load the bitstream to the flash with an ESP32 module. Writing an XDC file and configuring protocol (with VIVADO) for the above mentioned FPGA-chip is part of the task as well.
Identifikační číslo projektu: #16104261
O projektu
15 Freelnceři na tento projekt zveřejňují nabídky v průměru $1038
Hi I am experienced PCB designer with more than 8 years of experience in this field. Please have a look at my profile I have completed a number of projects we can discuss more if you are interested in working with m Další
Hello. I am expirienced hardware engineer. I made several devices with a similar architecture (FPGA with flash memory). Best regards!
Dear Sir, I am an electrical engineer with 18 years experience in this area . I am interested in your project, please send a private chat message.
Experience with FPGA, BGA lay outing, circuit design, PCB design. I use CADENCE software for PCB design, will be happy to discuss this further with you.
I have a high skill in pcb layout design and I have done PCB up to 20 layer If you provide circuit and part numbers of the components means I will design the PCB as your requirement So i believe to assist you perfectl Další
Hello sir, i have several years of experience in FPGA design, expecially on xilinx platform and ISE, and Vivado environment, if you want we can discuss about the project.
