14D439 Solidworks Drafting
$30-250 USD
K zaplacení v momentě doručení
the work required is as follows:
* review the 7 attached documents.
* bid on the job.
* draw the basic servo cylinder
* draw a flange based on the setout on the drawings and the approx measurements below.
* restrain the flange and apply a 250 bar pressure (use 250 MPa steel).
* increase the thickness of the flange till the stresses are under yield point.
* document in drawing template and PDF.
Approx. Dimensional Summary:
Inside Diameter: 420mm
Spigot Diameter: 430mm
Bolt PCD: 615mm
Flange OD: 705mm
No. Bolts: 16
Hole Size: 46mm
A key requirement is for the o-ring to sit on the newly installed sleeve, that means it must sit between approx 430mm ID and 450mm OD to prevent any water ingression between the liner.
Identifikační číslo projektu: #7036873
O projektu
Uděleno uživateli:
3 Freelnceři na tento projekt zveřejňují nabídky v průměru $151
looking forward to have your private message. -------------------------------------------------------------------------------------
