C code of the drivers of I2C ，SPI ，TIMER AND PWM

hi I am experienced electronics engineer with more than 8 years of experience. I have completed a number of projects with C code and all peripherals requested Please get in touch to discuss more in detail Regards

How are you? Like you see in my profile and portfolios, I have rich experience in C/C++, C#, and Python programming as well as microcontrollers. Especially, I completed many arduino and raspberry pi projects for such features. I would like to discuss with you and get more detail requirements. Please give me your details, then I will provide best solution for you. Thanks

Hi, I am a post graduate power electronics engineer and having very good experience in product design and development. I am excellent in embedded design & programming using pic, dspic controllers and MATLAB codding for Power projects, Boot loaders, Bluetooth & GPS designs, CAN communication, EEprom. UART , RF circuits ,Protocols for networking, wi-Fi routers,OBD diagnosis with CAN bus protocols, Electrical vehicles and AC drives, stepper motor controls. I designed sine wave inverters for standalone and grid tie Inverters. I designed projects like Off line UPS up to 3 KVA, 5kW motor controller for electrical vehicles ,synchronous rectifiers, Solar MPPT chargers, Solar trackers, Battery chargers ,Grid tie inverters design with PLL and feedback control circuit emergency light of 66W and Online UPS control cards, Battery Charging power supplies, LED drivers for PWM controlling and dimming, SMPS, Power supplies. I have experience in schematics and PCB design experience in Altium and ORCAD. I am ready to work for you. Please contact for further discussion.

Hi, I'm an expert in 32 bit microcontrollers and have worked with ARM micrcontrollers in more than 50 projects and I have good knowledge about ATSMADA micrcontrollers and their peripherals

I have experienced to developed software application and embedded application so i will make project as per your requirements

Experience in embedded C drivers development. Experience in communication buses : I2C, SPI, PCIe....

I have a Proven working experience in software engineering BS degree in Electrical and Electronics Engineering Experience in hands-on development and troubleshooting on embedded targets Solid programming experience in C or C++ Proven experience in embedded systems design with preemptive, multitasking real-time operating systems Familiarity with software configuration management tools, defect tracking tools, and peer review Excellent knowledge of OS coding techniques, IP protocols, interfaces and hardware subsystems Adequate knowledge of reading schematics and data sheets for components Strong documentation and writing skills.

I am electrical engineer having experience of 6 years in Embedded system. I have CGPA of 3.80, I have teaching experience and Teacher Assistant experience as well. I am enthusiastic. I have team of 5 engineering each have couple of years experience. I want to work with you in long term. I have wide experience in pic micro-controller, its ADC,DAC, PWM, EUSART, Comparator, internal Fosc configurations, EEPROM, timers, counters, interrupts, SPI, I2C and many other modules and communication interfaces.

i have good experience in software development with 8-16-32 bit microcontroller. having good knowledge of device driver and application driver code. Protocol: UART, SPI, I2C, RS232 Software: Matlab, Code composer(CCS), ?IAR Embedded Workbench, STM-STUDIO. Devices/Platforms: Arduino,Microcontrollers-->PIC,Atmel,STm,Texas Please contact to me on below. Mob/whatsup:-09510585566 Skype:-kamleshpatel01