Please only reply if you are an expert in this project.
Hi, I need help with a project I'm doing on a power factor improvement circuit using PIC16F887, I'm running the simulation on Proteus before making a prototype. Facing issue on PF reading on the LCD display.
The LCD should read current, voltage, and pf measurement of any load connected.
I already have a code, so just need to debug and look through the code to find errors or mistakes to make it run and display the current, voltage, and power factor of a load, then improve the pf.
Further details will be provided.
Hello there I am an expert embedded software developer with 5 years of experience in that field.
I have worked with the same microcontroller before + proteus ofcourse
I would like to know which compiler do you use and see your code
please contact me for more information
$90 USD v 1 dni
5,0 (28 recenze)
4,9
4,9
11 freelanceři nabízejí v průměru $152 USD za tuto práci
Hi.
I have good experience in PIC programming and proteus simulation.
If you give me a chance of interview, I will show my previous workings.
Please let me discuss about your project in detail.
Best regards, Andrii.
This bid is for verifying the power factor *measurement* and / or *display* only. If you need assistance with the power factor *correction* also, then I would need to treat that as an additional milestone.
There are a number of reasons why the values might not be displayed correctly:
1. problem in the voltage / current sensing circuits
2. incorrect ADC configuration / readings
3. mistakes in calculating the voltage / current from the ADC readings or the power factor calculation code
4. problems in the LCD display routines
Have you ruled out any or all of the above possibilities yet?
I use MPLAB X IDE version 5 and the XC8 compiler. If your development environment is different please let me know. (I use Linux so do not think I will be to replicate your circuit simulation using Proteus unfortunately). I have some spare 8-bit PIC microcontrollers at hand - so would at least be able to verify the LCD display, the ADC routines and the power calculations.
I am based in Ireland - GMT+1 timezone.
Hello Sir.
I can help your project perfectly.
I have 10 years good experience of hardware development including PIC programming. PIC16F877, PIC16F628, PIC18F46k22 etc.
I have completed a variety of embedded system design and programming by using microcontroller, arm, etc
Board PCB design have been completed by using Altium and Protel99SE.
Hope to cooperate with you.
Hi
I have 14 years experience in PIC microcontroller.I have both pic16f hardware and proteus simulator.
Please share your code and simulation file
I can debug and solve the issue
We can discuss
Regards
Senthil
Chennai, India
Hello
I have more than 15 years of experience in the embedded systems design and pcb design and electronics systems design
So let's discuss your project in chat
note: I have more than 15 years experience with pic microcontroller
.
Hello..
I am an electrical and electronics engineer.. I have very good experience in pic microcontrollers programming.. I have gone through your requirements and I am sure that I can do this project perfectly.. Kindly drop me a message through chat and provide me further details.. Looking forward to hearing from you soon.