My project consists of a 3 inch x 3 inch circuit board with test pads. There are only two components which are narrow pitch board to wire connectors. This board will have tests pads and test points. The design has been created in Illustrator so I can provide .ai and .eps design files for importing into circuit design software. Deliverables will be Gerber files for circuit board fabrication shop.
Note: In my opinion this is a very easy design project for the experienced circuit layout designer.
I am assuming the illustrator files will greatly shorten the time spent on the project.
I have attached a photo of a previously designed board with similar purpose and a spec sheet for the board to wire connectors.
Hi,
I am Electronics Engineer with 9 years experience in development, prototyping and testing of products.
Can I be the hardware supplier in a few days and for low cost.
I can supply a sample of product in 2 days after project e send for you for free.
If you have questions please contact-me by a email.
Best Regards
Adriano Campos